À Pengaruh Variasi Pemadatan Terhadap Karakteristik Marshall dengan Menggunakan Wood Ash Sebagai Filler pada Campuran Laston | Alamsyah | Jurnal Ilmiah Universitas Batanghari Jambi

Pengaruh Variasi Pemadatan Terhadap Karakteristik Marshall dengan Menggunakan Wood Ash Sebagai Filler pada Campuran Laston

Alik Ansyori Alamsyah, Azhar Adi Darmawan

Abstract


Indonesia's population is increasing exponentially, causing increased mobility. Therefore, it is necessary to increase the quantity and quality of roads to meet community needs. In Indonesia, hot mix asphalt, also known as hot mix, is the most common type of mix. Asphalt Concrete (AC) consists of asphalt as an adhesive, coarse aggregate and fine aggregate, and filler as a filling material, according to the 2010 BM specifications. All materials used in this research refer to the general specifications issued by the Directorate General of Highways in 2010 Revision 3, and the Marshall test will be carried out by replacing the Portland cement filler with Wood Ash in the Laston mixture. The asphalt used has a penetration of 60/70 and is used with compaction variations of 40, 50, 60 and 80 impacts. The research using wood asphalt as a filler showed a Marshall stability of 840.72 kg, a Marshall coefficient of 3.49 kN/mm, a film thickness of 6.64 μm, and an air mist volume of 4.59%.


Keywords


Laston; Variation of compaction; Wood Ash

Full Text:

PDF

References


Anonim, 1987, Petunjuk Pelaksanaan Lapis Aspal Beton (ATB) SKBI – 2.4.26, Departemen Pekerjaan Umum Direktorat Jenderal Bina Marga, Jakarta.

Abdullah, I. 2006. Konstruksi dan Reproduksi Kebudayaan. Yogyakarta: Pustaka Pelajar

Ansyori Al., Alik, 2015, Korelasi Antara Temperatur Pemadatan pada Campuran Aspal Beton Hasil Daur Ulang Terhadap Stabilitas Marshall, DPPM-UMM, Malang

Ansyori Al, Alik, 2005, Rekayasa Jalan Raya, UMM Press.

Direktorat Jenderal Bina Marga. 1999, Pedoman Perencanaan Campuran Beraspal Dengan Pendekatan Kepadatan Mutlak, Jakarta: Departemen Pekerjaan Umum

Direktorat Jenderal Bina Marga, 2010. Perkerasan Aspal. Spesifikasi Umum Bina Marga 2010, Divisi 6, Jakarta: Departemen Pekerjaan Umum

Sukirman, Silvia, 2003, Beton Aspal Campuran Panas. Granit, Jakarta.

SNI 06-2456-1991, Metode Pengujian Penetrasi Bahan-Bahan Bitumen.

SNI 06-2434-1991, Metode Pengujian Titik Lembek Aspal Dan Ter.

SNI 06-2433-1991, Metode Pengujian Titik Nyala dan Titik Bakar dengan Cleveland Open Cup.

SNI 06-2440-1991, Metode Pengujian Kehilangan Berat Minyak dan Aspal.

SNI 06-2432-1991, Metode Pengujian Daktilitas Bahan-Bahan Aspal.

SNI 06-2441-1991, Metode Pengujian Berat Jenis Aspal Padat.

SNI 03-1737-1989, Pelaksanaan Lapis Campuran Beraspal Panas.

Waani, J.E., 2013. Evaluasi Volumetrik Marshall Campuran AC-BC. Manado: Universitas Sam Ratulangi.




DOI: http://dx.doi.org/10.33087/jiubj.v24i1.4734

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

ADRESS JOURNAL

JURNAL ILMIAH UNIVERSITAS BATANGHARI JAMBI (JIUBJ)
Published by Lembaga Penelitian dan Pengabdian kepada Masyarakat
Adress: Jl.Slamet Ryadi, Broni-Jambi, Kec.Telanaipura, Kodepos: 36122, email: jiubj.unbari@gmail.com, Phone: 0741-670700

Creative Commons License This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.